I thought about which printer to buy and came to the conclusion that Voron 2.4 based on FLY-F407ZG with CoreXY rail mechanics and a print area of ​​350x350x350mm is the best option.

Control board with Wi-Fi 500 Kilobits for Voron printers: FLY-F407ZG + Wi-Fi TMC2209 RepRap 32 Bit. SPC5744PFK1AMLQ9

AR8033-AL1A Kit for Voron 2.4 CoreXY 3D printer.350x350x350mm.

It will cost approximately 50,000 rubles.(Excluding power supply, control board and Raspberry Pi 4)

I will buy everything separately, probably the frame separately, acrylic sheets too, all parts will be about 10,000 rubles each.and clear customs.In 60 thousand, in theory I fit.

I don’t understand why the printer, which is sold as a single Raspberry Pi 4 kit, has it there instead of a screen?

The problem, of course, is that I can’t even imagine what kind of design the 3D printer has, what is where and how it should work, I hope that the assembly instructions exist somewhere.

What do you think about the assembly on such a control board?

Which direct extruder to buy for him, did not figure it out.

Aliexpress offers such a direct extruder option as a novelty in 2021: All-metal active two-tooth extruder.

How good is this direct extruder and how suitable is it, what are the alternatives?

Will you share the model?

I didn't really like it either...

Well, the campaign is the one who did it at all ...

Hello, on the end printer...

Please tell me I'm typing...

New registration data has been sent to your e-mail.

An email has been sent to you with instructions to reset your password.If you haven't received an email within 5 minutes, please check your spam folder and try again.